- You cannot place a new order from your country (United States).
search
Hangers Super Fix 2x34kg
The Super Fix hangers are a set of two grow tent suspension hooks, each rated to 34 kg. They hold a reflector or an activated carbon filter at the required height and hook over a bar of the tent frame without tools. Height is adjusted afterwards without unhooking the load. Worth noting when sizing a setup: the frame, not the hook, usually sets the real limit.
Super Fix hangers 2 x 34 kg – suspension for reflectors and carbon filters
The Super Fix hangers are a set of two grow tent suspension hooks, each rated to 34 kg. They carry a reflector or an activated carbon filter, hook over a bar of the tent frame without tools, and remain height-adjustable once fitted. Intended for growers hanging heavy kit without drilling fixed anchor points.
Tool-free fitting, and just as quick to move
The hooks rest over the upper bars of the frame, so there is no drilling, no screwing and no bracketry involved. A filter or reflector can therefore be repositioned as easily as it was hung, which matters as canopy height shifts through the cycle. Where frequent adjustment is expected, pairing the hangers with an Easy Roller allows the load to be raised or lowered one-handed.
The frame is usually the real limit
- Set of two hooks, each rated to 34 kg
- Suited to reflectors and activated carbon filters
- Spread the load across two anchor points, never one
- Check the tent manufacturer's stated maximum first — it is often the lower figure
For lighter duty, such as supporting branches and heavy tops, the Yoyo plant support is the logical companion: it is designed for plants rather than for equipment.
Shipped from Belgium throughout the Benelux; rollers, pulleys and mounting accessories sit in the same catalogue category at plantandflower.be.
How much weight do the Super Fix hangers hold?
Each hook is rated to 34 kg and the set contains two. That covers the reflectors and carbon filters normally used inside a grow tent. Always spread the load across both hooks, and confirm that the tent frame itself can carry the total weight of the installation before hanging anything from it.
Do they fit every grow tent?
Because they hook over a bar rather than bolt to it, they are not brand-specific. The variable is bar diameter, which is greater on reinforced frames. Measure the upper bar before ordering if there is any doubt, and factor in the maximum load stated by the tent manufacturer rather than the hook rating alone.
How do they differ from an Easy Roller?
The hangers are the anchor point itself; the Easy Roller is a pulley system fitted between hanger and load to change height quickly. A fixed installation needs only the hangers. A setup that tracks plant growth through the cycle justifies adding the roller, which saves unhooking the load at every adjustment.
